XTEMOS ELEMENT
AJAX PRODUCTS TABS
Constant Volume Air Thermometer
Description
A metal stand fitted with 0-100 cm x 1 mm vertical wooden scale and supporting a mercury reservoir sliding on a metal rod. An air thermometer bulb fitted to a bracket can be attached to the other rod at either of two positions. With U-shaped base. Complete with 1 meter rubber tubing to connect reservoir to the bulb. Supplied without mercury.
LPC 2148 Development Kit
ON Chip Features
• CPU - LPC2148. • Core - 16/32 Bit ARM7TDMI-S. • Speed - Max 60 MHZ. • Flash - 512KB. • RAM (on-chip) - 40KB. • 46 x General Purpose I/O Pins. • USB2.0 Full speed Compliant Device. • One 10bit ADC with 14 Analog inputs. • One 10bit D/A Converter. • Two 32bit Timers/ External Event Counters. • Low Power Real Time Clock. • Six PWM & Watchdog. • Two UARTS (16c550). • Two Fast I2C (400Kb/s) Module.On-Board Features
• Two Digital output. • Two Digital input. • 10 base T Ethernet Interface. • USB 2.0 Connectivity. • SD Card Interface. • 16 x 2 character LCD Interface. • 2 Analog Inputs are Terminated at Potentiometer. • RS232 lines are terminated at 9 pin D-type connector. • CPU lines are terminated at 20 pin connector.XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Signal Generator
1 Hz to 100 KHz in five decade ranges selected by rotary switch named as frequency Multiplier. Sine Triangular and Square waveforms selected by push switch with LED indication. Output signal is 0-3.5 V rms (10 V peak to peak) open circuit continuously control with uncalibrated amplitude control knob. Mains rocker switch with indicator Light. Signal Generator is versatile for general laboratory use; output signal is adjustable with the combination of Freq. multiplier and set frequency dial with a low level of distortion. Output Voltage is continuously variable with selector range 1V and 10V. There is two pair of output safety sockets. One for CRO output (experiment for amplification, filter etc.) and another pair of sockets to speaker to drive a speaker and to demonstrate the audio signal frequency range 20 Hz to 20 KHz.
Coil Ignition System Of An Automobile
RF Telemetry
RF telemetry system consists of a radio frequency transmitter and matching radio frequency receiver both operating at 433 MHz. The system is designed for the radio frequency transmission and reception. The radio frequency transmitter sends out a variable audio signal and the radio frequency receiver with built in loud speaker receives the signal. The system enables the teachers to demonstrate a variety of wave phenomenon. The system also enables the properties of the radio communications to be investigated and compared with those of visible light and other wave motions such as audible sound and water waves etc. For the operation of the system, a 9 V PP3 battery is required.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Typical Flower
Four Stroke Single Cylinder Diesel Engine Trainer Rig
Features
• One Thermocouple provided to measure the temperature at exhaust. • One temperature indicator provided to display the temperature. • A CC tube provided to measure the fuel consumption by the engine. • Stop watch provided to measure fuel consumption in time basis • A Tachometer provided to measure the speed of the engine. • An air drum provided to measure the intake air flow. • An U-Tube manometer provided to measure the pressure head of intake air flow. • Fuel panel provided to fix the CC tube and fuel tankSpecification
• Make :Kirloskar • Power : 6 HP • Speed : 1500 rpm • Cooling type : Air cooled • Start : Hand Start • Loading type : Eddy current brake (or) • : Electrical Load (or)  
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
St. Louis Motor Demonstration
Description
Students can explore how a simple electric motor works by doing a series of investigations. This St. Louis motor can be adjusted so students can study the effect of voltage and position of the brushes on the commutator. The motor consists of a two pole DC armature. The brush holder, with two heavy binding post terminals, can be rotated for experiments. The permanent bar magnets, supported by clamps, can be adjusted to the desired location. This apparatus requires 4 D cell batteries with holder (not included) or a power supply and two connecting leads (not included).
Linear Expansion Apparatus
Consisting of a metal rod, 500mm in length and 4.5mm diameter, enclosed in a well lagged, nickle plated brass tube with three tubules for steam, inlet, outlet and thermometer.
The metal rod to be studied is supported in the steam jacket by detachable conical cups situated at each end of the tube.
The apparatus is carried on a heavy gauge channel base at one end of which is an adjusting screw.
At the opposite end is a micrometer screw reading to 0.01mm for measuring the expansion.
Supplied complete with copper, brass & iron rods but without thermometer.
Balance Compression
5000g capacity with 25g subdivisions
Zero adjustment knob
Includes: (1) Balance
Balance Compression, Capacity 5 Kgs.
(1) Balance
Useful for weighing chemicals and general purposes. Made of plastic body with wide view dial and easily readable scale.
Most durable and provided with zero adjustment knob.
Cap : 5kg Sub division : 25g
DDS RF Source and Network Analyzer
This unique instrument is RF source upto 1.7GHz with 10 to 400MHz in DDS mode of operation and few Network Analyzer capabilities.
Specification
• It works in two mode of operation. - 10 to 400MHz - DDS operation. - 400 to 1700MHz - PLL operation. • 10 to 1700MHz, RF signal generator. • RF Output Power: 10 to 400MHz, -2dBm, +/-3dB 400 to 1700MHz, -5dBm, +/-3dB. • Harmonics: 10 to 600MHz better than -15dBc 600 to 1700MHz better than -30dBc. • Attenuation: 5dBm, 10dBm, 20dBm, 30dBm. • Fixed and sweep RF signal source. • Direct digital synthesis (DDS) method based. • 100 KHz Channel step size. • AM/FM Modulation. • Automatic Level Control (ALC) incorporated so that, RF level output will be constant. • Graphics LCD display to plot Filter, Amplifier etc., characteristics.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Analog PID Controller
The analog PID controller is a special purpose analog controller with operational amplifiers The controller permits a detailed analysis of the application of proportional, integral and derivative control to the improvement of their performance. The controller may be used at high speed for oscilloscope observation or at a low speed for meter observation.
FEATURES:
• Two analog meters (centre zero meters) to display the set variable and process variable. • In built regulated power supply. • Provision to vary and measure the setpoint (0-5)V • Provision to vary the proportional gain, Integral time and derivative gain. • Provision to give either (4-20)mA or (0-5)V externally as a process variable. • Provision to select the controller output as (4-20)mA or (0-5)V internally. • All the components are mounted in an attractive cabinet. • Interface with any realtime process (Level, Flow, Temperature, Pressure, DC motor speed control etc.,)
Conductors and Insulators
Cryo Rack
Our Cryo Rack is moulded in polycarbonate making it tough, durable & autoclavable.
This handy Cryo Rack can hold 50 vials can be unscrewed without actually picking them up as the vial will lock in every well and hence will not twist.
This rack is provided with four anti skid rubbers & each well is identified with an alpha-numeric index.
Material : Polycarbonate
| Particulars | Pack (Pcs) | |
|---|---|---|
| Cryo Rack | 2 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
TMS320C6747 Based DSP Trainer
KEY FEATURES:
• TMS320C674x Fixed/Floating-Point VLIW DSP Core Operating upto 300MHz • 64 General-Purpose Registers (32 Bit) • Six ALU (32-/40-Bit) Functional Units • Two Multiply Functional Units • Instruction Packing Reduces Code Size • All Instructions Conditional • Hardware Support for Modulo Loop Operation • On Chip RTCON-CHIP MEMORY:
• Two Level Cache Memory Architecture • 32K-Byte L1P Program RAM/Cache • 32K-Byte L1D Data RAM/Cache • 256K-Byte L2 Unified Mapped RAM/Cache • 128K-Byte RAM Shared MemoryON-BOARD FEATURES:
• Boot mode selection Switch • 1M x 16 Bit x 4 Bank SDRAM. • 10/100M Ethernet Interface • USB1.0 & USB 2.0 Interface. • Embedded JTAG for Emulation. • 8 LED & 8 Switch for user Interface. • Expansion Connector For GPIO & Peripheral Interface. • VSDA Expansion Card for 4 Channels ADC & 4 Channels DAC. • Provision to connect external JTAG Emulator • RS232 Serial Port Interface
Lab Tubing Connectors
We are engaged in providing high quality range of Lab Tubing Connectors.
These Lab Tubing Connectors are sourced from highly reliable manufacturers who ensure the usage of high grade components for its manufacturing.
Our clients have always appreciated our range of Lab Tubing Connectors for its supreme quality and durability.
our Lab Tubing Connectors comes in a wide range which includes Cross Connector , Y Shaped Connector , L Shaped Connector and T Shaped Connector.
| Particulars | Pack (Pcs) | |
|---|---|---|
| T-Connector 6 mm | 36 | |
| Y-Connector 6 mm | 36 | |
| T-Connector 8 mm | 36 | |
| Y-Connector 8 mm | 36 | |
| T-Connector 10 mm | 36 | |
| Y-Connector 10 mm | 36 | |
| Cross Connector-6 mm | 36 | |
| Cross Connector-8 mm | 36 | |
| Cross Connector-10 mm | 36 | |
| L Connector-6 mm | 36 | |
| L Connector-8 mm | 36 | |
| L Connector-10 mm | 36 | |
| Pinch Clip | 12 |
