XTEMOS ELEMENT

AJAX PRODUCTS TABS

Featured
  • Featured
  • Accessories
  • Furniture

Linear IC Trainer

This Trainer Consist of : 1. Regulated power supply of ± 12 V / 250 mA. 2. Variable 0 to ±5 V / 250 mA. 3. Sine wave oscillation of 1 KHz. 4. Digital Voltmeter of 0-20 V DC, LCD display, 3 ½ Digit. 5. Functional diagram of IC 741 is printed with 2 mm sockets. 6. One extra 8 pin IC Base with 2 mm sockets. 7. Potentiometer of 10K Ohms. 8. Required Resistance and Capacitances mounted on board. 9. Interconnection Leads and Manual to perform 15 experiments on IC741 e.g. inverting, non-inverting, summing, difference, multiplier, differentiator, integrator etc.

Balance Compression

5000g capacity with 25g subdivisions Zero adjustment knob Includes: (1) Balance Balance Compression, Capacity 5 Kgs. (1) Balance Useful for weighing chemicals and general purposes. Made of plastic body with wide view dial and easily readable scale. Most durable and provided with zero adjustment knob. Cap : 5kg Sub division : 25g

Water Bath Incubator Shaker

Specifications

Similar to other water bath but fitted with inbuilt shaker for differrent experiments demanding shaking at constant speed under controlled temerature conditions. The temprature is controlled by capillary type thermostat from ambient to 100°C. RPM range :- 40-140 with variable electronic speed regulattor workable on 220V AC 50 Hz Single Phase.
Chamber Size In mms (dia x depth)Capacity (L) 
275x275x15012 L 
405x300x15018 L 

Optional (Extra Cost)

Microprocessor PID digital temp. indicator cum contrroller. Digital RPM meter. Auto cut off device when water level is low.
XTEMOS ELEMENT

AJAX PRODUCTS TABS SIMPLE

shirt-tab
Fashion
Featured
  • Featured
  • Man
  • Woman

Elastically Coupled Beam Apparatus

Apparatus consists of a three parallel bar suspension system with elastic beam at their upper and lower ends. The upper ends of the two outer suspension rods are tied to a vertical wooden board while central suspension rod may be tied to the centre of another elastic beam supported at two outer ends only. Mild steel Apparatus to be supplied should be complete with a supporting stand and a set of weights.

Telescopic Alidade

Description

• Telescopic alidade with compass on brass base and foot screws & bubble, • Compass dia 8.8 cms, • Telescope's lens 25 mm. • Magnification 15 X, • Telescope extended: 32 cms, collapsed 23 cms,

Seekers

Stainless Steel with blunt end Needle.

Spectrometer, Advanced

Description

Vernier reading to 30 seconds of arc. The 175 mm diameter scale is fixed. The table and telescope movements are completely independent of each other and read to 30 seconds of arc by means of double ended verniers and magnifiers. Both rotations have fine adjustment screws. Coarse adjustments can also be made by release of clamping screw. Collimator is mounted on a fixed pillar and is fitted with 175 mm fl. achromatic objective with 32 mm clear aperture and a laterally adjustable slit 6 mm long. Telescope is mounted on a movable pillar fitted with 175 mm fl. achromatic objective of 32 mm clear aperture and x 10 Ramsden eye-piece with a glass cross line graticule. Both the telescope and collimator have rack and pinion focusing and can be adjusted for leveling the axes of both units as well as for adjusting to the axis of rotation. Prism table is marked with lines to assist prism placement and has three table leveling screws. It also has an interchangeable clamping unit for the prism and diffraction grating. Complete with prism clamp, diffraction grating holder and a Tommy bar for adjusting optical axis, In case.
XTEMOS ELEMENT

AJAX PRODUCTS TABS ALTERNATIVE

Fashion
Featured
  • Featured
  • Man
  • Woman

Medical Microscope

Specification

Medical Microscopes is a straight tube monocular research microscope. The body can be inclined up to 90° with separate coarse and fine adjustment. Triple revolving nose-piece, double lens condenser numerical aperture of 1.2 with iris-diaphragm and rack-n-pinion adjustment. Fixed slide stage with detachable mechanical stage, plano-concave reflecting mirror inter-changeable with removable LED microscope lamp. With 10x, 15x or 5x hymenia eyepieces (2 Nos.) 10x, 45x, 100x oil-immersion (spring loaded) achromatic objectives. Magnification : up to 1500x.

Tuning Forks

Description :- Set of eight copper pipes with tuning fork (256 Hz) to show how resonance tones can only be created from certain pipes. O-rings are attached to the ends of the pipes which protects the tubes from the drop In.

Pisces

Description

All Charts are made on PVC rexine, hand drawn, waterproof, in fast multi colors with a black background. Each chart is provided with rollers to hang on wall. Size 75×100 cm. Scoliodon External Character Scoliodon General Viscera Scoliodon Digestive System Scoliodon Skeleton Scoliodon Male Urinogenital system Scoliodon Female Urinogenital system Scoliodon Venous system Scoliodon Cranial Nervous system Scoliodon Recepter organs Labeo Rohita External character Labeo Rohita Axial Skeleton Amphioxus External character Amphioxus General anatomy Amphioxus T.S. through different regions Amphioxus Development Amphioxus Excretory system

Fluid Mechines Hydraulic Machines Models

FLUID MECHANICS & HYDRAULIC MACHINES MODELS 1. Hook Gauges 2. Venturimeters & Orificemeters 3. Manometers (A) Pitot Tube (B) U Tube Double Column Manometer (C) Differential Manometer (D) Inclined Manometer 4. Valves Models (A) Hydraulic Non Return Valve (B) Gate Valve (C) Globe Valve 5. Turbines & Pumps Models (A) Different Impellers Of Pumps And Turbines (Set Of 8) : (i) Mixed Flow Runner Cast Aluminium (ii) Axial Flow Runner Cast Aluminium (iii) Radial or Centrifugal Runner Cast Aluminium (iv) Kaplan Runner Cast Aluminium (v) Francis Runner Cast Aluminium (vi) Domestic Self Pumping Runner of Brass (vii) Centrifugal Runner Actual Cast Iron (viii) Pelton Wheel Runner Cast Aluminium (B) Display Board For Pipes (C) Hydraulic Elevator: (D) Hydraulic Ram Non Working Model (E) Pelton Turbine Model (F) De-Lavel Turbine Model (G) Kaplan Turbine Model (H) Francis Turbine Model (I) Impulses Turbine Working Model (J) Air or Steam Pressure Turbine Model (K) Pure Reaction Turbine Model (L) Radial Turbine Model (M) Gear Pump Model: (N) Rotary Pump (O) Centrifugal Pump : Actual Cut Section (P) Reciprocating Pump : Actual Cut Section (Q) Model Of Air Lift Pump Model (R)Pendulum Pump Model (S) Archemedian Screw Pump Model (T) Tubewell Model : (U) Deep well Turbine Pump Model (V) Submersible Pump Model (W) Hydro-Electric Power Installation Model
XTEMOS ELEMENT

AJAX PRODUCTS TABS ARROWS PAGINATION

shirt-tab
Electronics
Featured
  • Featured
  • Mobile
  • Smartwatches

Set of Springs

Closely wounded Steel extension springs with loops at both sides, dia 6 mm approx. Closely wound with loops at both sides, dia. 6 mm approx. wire of 19 swg. Length 150 mm, Extension 230 mm average for 200g load

Petri Dish Rack

We offer comprehensive range of Petri Dish Rack to our valuable clients. These Petri Dish Racks are clear acrylic construction with polycarbonate posts. Our range of Petri Dish Rack has a capacity to hold 60 petri dishes of 90 mm size while Petri Dish Rack can hold 56 petri dishes of 60 mm. Useful during inoculation, incubation & storage, Petri Dish Rack enables the culture to be seen & checked during. Material : Polymethyl Methacrylate / Polycarbonate
ParticularsPack (Pcs) 
Rack For 90 mm Petri Dish2 
Rack For 60 mm Petri Dish2 

LABORATORY AND MEDICAL MONOCULAR MICROSCOPE

PRODUCT DESCRIPTION: Being a leading firm in this industry, we are deeply engaged in offering a high-quality range of MS 30 Medical Monocular Microscope. Details:
  • MS-30 Student Monocular Compound Microscope
  • Viewing Body Monocular tube, Straight,
  • Stand Monocular, frame inclines back to 90°
  • Eyepiece eyepiece 10x
  • Nosepiece Quadruple revolving Nosepiece
  • ObjectivesSA series Achromatic objectives 10x/ NA 0.25 , 40x/ NA 0.65 (SL) , 100x/ NA 1.25 (SL, Oil)
  • Stage Stage plate size 124 x 120mm with Mechanical stage for X and Y movement of slide up to 30 x 75mm with graduated scale and Vernier’s
  • Focusing Separate coarse and fine focus controls. Coarse movement by Rack & Pinion and fine movement by Screw Lever Mechanism
  • Condenser Sub-stage Iris diaphragm with moving up and down through rack and pinion, condenser NA 1.25 with Blue Filter
  • Illumination System Plano concave reflector mirror mounted at the base
  • Package Contents Thermocole Box, with operation manual, dust cover and cleaning cloth

Fluid Mechines Hydraulic Machines Models

FLUID MECHANICS & HYDRAULIC MACHINES MODELS 1. Hook Gauges 2. Venturimeters & Orificemeters 3. Manometers (A) Pitot Tube (B) U Tube Double Column Manometer (C) Differential Manometer (D) Inclined Manometer 4. Valves Models (A) Hydraulic Non Return Valve (B) Gate Valve (C) Globe Valve 5. Turbines & Pumps Models (A) Different Impellers Of Pumps And Turbines (Set Of 8) : (i) Mixed Flow Runner Cast Aluminium (ii) Axial Flow Runner Cast Aluminium (iii) Radial or Centrifugal Runner Cast Aluminium (iv) Kaplan Runner Cast Aluminium (v) Francis Runner Cast Aluminium (vi) Domestic Self Pumping Runner of Brass (vii) Centrifugal Runner Actual Cast Iron (viii) Pelton Wheel Runner Cast Aluminium (B) Display Board For Pipes (C) Hydraulic Elevator: (D) Hydraulic Ram Non Working Model (E) Pelton Turbine Model (F) De-Lavel Turbine Model (G) Kaplan Turbine Model (H) Francis Turbine Model (I) Impulses Turbine Working Model (J) Air or Steam Pressure Turbine Model (K) Pure Reaction Turbine Model (L) Radial Turbine Model (M) Gear Pump Model: (N) Rotary Pump (O) Centrifugal Pump : Actual Cut Section (P) Reciprocating Pump : Actual Cut Section (Q) Model Of Air Lift Pump Model (R)Pendulum Pump Model (S) Archemedian Screw Pump Model (T) Tubewell Model : (U) Deep well Turbine Pump Model (V) Submersible Pump Model (W) Hydro-Electric Power Installation Model
XTEMOS ELEMENT

AJAX PRODUCTS TABS WITH ICONS

Furniture
  • Furniture
  • Lighting
  • Accessories
  • Clocks
  • Cooking

PNEUMATIC TROUGH

PRODUCT DESCRIPTION: Use a circular Glass Circular Pneumatic Trough made of soda lime glass to conduct gas analysis experimentation in the laboratory. A secondary use is for specimen storage Features:  
  • Circular soda lime glass
  • For collection of gases over water
  • Three sizes
    Size: 15*10cm 20*10cm 25*10cm 30*12.5cm

Staining Racks

All Slides are held horizontally. Collapsible handles on both sides. Size 25 Slides 50 Slides 100 Slides

Water Turbine with Dynamo

Description

To show conversion of mechanical energy into electrical energy. Turbine with transparent cover, inlet and outlet tubes, directly connected to a dynamo. Fitted on base.

Bio-Agent Cage Acrylic

Description

Made of transparent acrylic sheet. Front & Both sides with 15cm round opening in the centre with white thick muslin cloth sleeves. Front opening with tight fitting support on transparent acrylic batons.  Size : 30x30x30cm.
XTEMOS ELEMENT

AJAX PRODUCTS TABS LOAD MORE PAGINATION

Featured
  • Featured
  • Lighting
  • Accessories

SILICA CRUCIBLE WITHOUT LID

PRODUCT DESCRIPTION
  • Crucible is glazed inside and outside.
  • Highly resistant to alkalis and hot temperatures
  • 50ml capacity
  • Outside diameter 55mm, 42mm height
  • No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML

SILICA CRUCIBLE TALL FORM Without Lid, Translucent

PRODUCT DESCRIPTION -Without lid, translucent, glazed - Ordinary type lids to be purchased separately Size/ dimension:
  • 20ml,  Dia. 35mm x Ht. 38mm
  • 30ml, Dia. 43mm x Ht. 38mm
  • 50ml, Dia. 51mm x Ht. 51mm

SILICA MUFFLE TRAYS (For VM Crucible)

PRODUCT DESCRIPTION:   Available in 2types:  Two Hole, 39mm Length Four Hole, 76mm Length
XTEMOS ELEMENT

AJAX PRODUCTS TABS CAROUSEL

Featured
  • Featured
  • Cooking
  • Furniture