XTEMOS ELEMENT

AJAX PRODUCTS TABS

Featured
  • Featured
  • Accessories
  • Furniture

Sieve Shaker (Gyratory Motion)

Ensuring durability during performance, this machine is made of mild steel and cast iron and comes with one Lid and a Pan. This unit is used with up to 7 sieves of 150mm or 200mm (8 Inch) sieves and up to 6 sieves of 300 mm (12 Inch). Heavy duty motor (1/4 HP) ensures the whole performance through a reduction gear immersed in oil. Along with featuring gyratory motion, this units also performs upward and downward movement ensuring that each "square cm" of the sieve is fully utilized. This Gyratory Sieve Machine also supplied with a pair of rods and a holder which ensures tight grip of sieve set from the top.
Product:Gyratory Sieve Shaker 
Capacity:7 sieves of 150mm, 6 sieves of 300mm 
Design:Table Top 
Construction: Cast Iron, Painted Mild steel 
Motor: ¼ HP 
Timer: 0 - 60 Minutes 
Timer Type: Digital / Analog 
Power Supply: 220 Volts 

Tuning Fork, Electrically Maintained

Description :- On sturdy base, can be used in horizontal or vertical position. Prong size is 300 x 25 x 10 mm. Actuated by an electromagnet between the prongs, works with 6 V D.C. Amplitude of vibration can be varied by adjusting the position of the electromagnet.

Orsted’s Apparatus

This demonstrates the action of electric current on a magnet. A cobalt steel needle with agate bearing supported by pivot is mounted on a plastic base and surrounded by rectangular frame fitted with terminals.

Digital Stroboscope

Description :- Stroboscopic flashes are triggered by either the internal oscillator or by external pulses which may be connected to the two 4mm sockets mounted on the rear panel of the instrument. Example of the many applications of this unit are to be found in motion analysis multi exposures photography, examination of moving parts and measurement of rotational speed. Specifications:- Input Volts : 220V AC, 50 Hz Flash Rate: 0- 9999 Flashes per minute. Resolution : 1 Display: 7 Segment LED (4 nos.)
XTEMOS ELEMENT

AJAX PRODUCTS TABS SIMPLE

shirt-tab
Fashion
Featured
  • Featured
  • Man
  • Woman

Weighing Bottle, Tall Form, Cap Type

O.D. x Ht. mm (approx.)Capacity ml
18 x 4020
28 x 5025
38 x 6055
45 x 80100

Ball & Ring GRAVESANDE

Description

Gravesende's mounted in rod with handle, ball with chain. Cold ball passes through the ring but does not pass when heated.

Autoclave Vertical Sterilizer

Specifications

Made of stainless steel with the inner chamber of a thick pressure gauge. The outer surface has a mirror polish. The lid of this autoclave is thick along with a safety valve, pressure release valve, and drain valve. Spring loaded valve to adjust the pressure. Works on 220V AC. Radial or wing nut type door locking. Digital temperature indicator. Water level indicator.
DimensionPowerCapacity 
250x450mm 2KW22litres 
300x500mm 3KW40litres 
350x550mm 4KW50litres 
400x600mm 5KW75litres 
450x600mm 5KW95litres 
550x750mm 6KW187litres 
XTEMOS ELEMENT

AJAX PRODUCTS TABS ALTERNATIVE

Fashion
Featured
  • Featured
  • Man
  • Woman

Refrigeration Trainer Domestic Type

The unit enables students to study the various parameters affecting the performance of a domestic refrigerator. It consists of refrigeration cycle of domestic refrigerator, it consists a hermetically sealed compressor, air-cooled condenser, capillary tube and a natural convection type evaporator. The evaporator is fitted with a small heater to simulate different load conditions various measurements are provided so that power consumption, COP, theoretical and actual refrigerating effects refrigerant flow rate and effect of door opening on power consumption can be studied and also students can visualize automatic operation of unit using a thermostat.

SPECIFICATIONS:

1.Compressor – Hermetically sealed, Kirioskar make having capacity of approx. 1/25 ton of refrigeration. 2.Air – cooled condenser with natural convection airflow. 3.Capillary tube of matched length as expansion device. 4.Evaporator coil with an electric heater inside and adequate glass wool insulation on all side. 5.Measurement a)Energymeter Tore compressor input power measurement. b)Pressure gauge for condensing and evaporating pressure. c)Flow meter for liquid refrigerant flow d)Digital Temperature indicator for measurement of temperature 6.safety & Controls a)High & low pressure cutout. b)Thermostat. c)Necessary Switches. A technical manual accompanies the unit. Also, the unit is provided with an attractive and rust proof powder coating.

SERVICES REQUIRED:

1.Floor space of 2m x 1m. 2.230V AC stabilized supply with earthing connection

Rubber Hammer, Medium

Description :- For activating tuning forks. Rubber ball is mounted on a sturdy, wooden handle.

Larynx, 2 Parts

Description

Natural size, 2 parts, shows larynx, wind pipe, ligaments, muscles and thyroid gland, one half is removable. on base, with key card.

PAM-PPM-PWM Modulation and Demodulation Trainer

PAM- PPM- PWM is the basic pulse modulation techniques. This trainer provides complete setup to the students for performing Experiments on these techniques. They can study Sampling, Pulse Modulation &Signal reconstruction process. Separate circuits are provided for each Techniques.

FEATURES:

• PAM- PPM- PWM Modulation and Demodulation Techniques,using Natural and Flat - top Sampling. • Natural Sample, Sample and Hold and Flat-top outputs. • Selectable 2 different sampling pulse frequencies on board. • On board Sine wave generators. • Voice communication using dynamic microphone and speaker • On board Filters and Amplifier • Functional blocks indicated on board schematic • Input- Output and Test points provided on board. • Built in DC Power Supply • Fully documented operating Manual

TECHNICAL SPECIFICATION:

• Crystal Frequency : 6.14MHz • Sampling Frequency : 16 KHz, 32 KHz • Sine wave Generator : 1 KHz &500Hz, Amplitude (0-5)V, Tolerance +5% • Low Pass Filter : 4 Order BW Filter • Cut off frequency : 3.4 KHz • Voice Communication : Voice Link using dynamic mic& speaker • AC Amplifier : With Adjustable Gain control • Microphone type : Dynamic, 600 Ohm. • Audio Pre-amplifier : Op-amp based • Power amplifier : 1W Mono • Interconnections : BS2 Connector. • Power : 230V, 50Hz
XTEMOS ELEMENT

AJAX PRODUCTS TABS ARROWS PAGINATION

shirt-tab
Electronics
Featured
  • Featured
  • Mobile
  • Smartwatches

Power Supply for Electrophoresis

Description

Electrophoresis power supply, Analog Fixed Current 250 mA and also 5 type of fixed voltage means 50V,100V, 150V, 200V and 250V. It is recommended for mini Horizental and mini vertical Electrophoresis Apparatus.

Comparative Terrain Model

Description

Set of 2 landform models, each includes an overlay representing ancient mountain forms that can be removed and compared with the base model to show changes millions of years later. Cross section shows basic mountain types, volcanic fault block, glaciated domes and folded mountains with lesson plan, size 45 x 60 cm.

Main Voltage Coils, For Demountable Transformer

Description

Wound on rectangular bobbin, for use with 220 – 240 V AC mains with detachable mains connector with moulded plug, A 4 mm socket is provided for earthing.

Insect Collecting Net’ Executive’ (Telescopic)

Description

Insect Collecting Net, Executive, with Telescopic Handle adjustable from 55cm to 180 cm. Provided with carry bag. Insect Collecting Net With Aluminium Handle , Folding Ring. Insect Collecting Net With Aluminium Handle, Dual Purpose. Insect Collecting Net With Iron Handle, Triangle Type.
XTEMOS ELEMENT

AJAX PRODUCTS TABS WITH ICONS

Furniture
  • Furniture
  • Lighting
  • Accessories
  • Clocks
  • Cooking

Electromagnet

Description

Comprising iron U-shaped core of circular section, with armature and carrying hook. Wounded with insulated copper wire and provided with connectors for use on 4-6 volts D.C.

Plant Structure II – Gymnosperms, Ferns, Mosses & Liverworts

Set of 17 Slides, comprising Dryopteris, TS pinnule with sori Dryopteris, TS Rachis Dryopteris, TS rhizome Funaria, LS of capsule Lycopodium, TS Stem Marchantia, VS thallus Moss, LS antheridial Head Moss, Leaf WM Pinus, TS young root Pinus, LS male cone with microscopers Pinus, LS whole female cone Pinus, Pollen Pinus, stem macerated Pinus, TS leaf Pinus, TS old stem Polytrichum, TS stem

6 Axis Robotic Trainer

For beginners this kit is very useful to learn the concept and working. For experienced, this kit helps to make new ideas. This kit is used to study the ROBO characteristics of arm movement. Each axis has one stepper motor. Gripper has one miniature cylinder to pick and place the object. Software controls the ROBO arm and measures the motor axis and arm axis. Simplicity of this kit makes maintenance easier and friendly to user. This kit is very flexible to operate and easy to move.

Features

• Easy to learn • New design • Easy for maintenance • Drive by stepper motor • Easy to program

Specification

• Arm : Jointed Arm • Axis : 6 • Motor : Stepper Motor • Gripper : Pneumatic • Drive : Stepper Motor Drive • Controller : Microcontroller

Base

• Angle of movement : 320º • Gear Type : Spur Gear • Position Detector : Limit Switch

Intermediate ARM

• Angle of movement : 90º • Gear Type : Spur Gear, Worm Gear • Position Detector : Limit Switch

Vertical ARM

• Angle of movement : 90º • Gear Type : Spur Gear • Position Detector : Limit Switch

Perimeter Smith Type

Specifications

Material : Stainless Steel Color : Black

Product Description

The perimeter is an instrument for accurate charting of the field of vision. It consists of. A vertical stand on which a metallic arc is pivoted. It also bear a circular black disc to read the meridian in which the arc in shape of a semicircle with radius 330 mm. Its rotating in any direction and fix at any position with a tightening screw. The arc is graduated from 0 to 90 with a movable test object which is a white color spot of size 10mm diameter painted on a circular disc it can be moved with arc. An adjustable chin rest and a detachable leveling bar is fixed in front of the metallic arc. A scale and circular chart frame to hold the chart paper in position is provided at the back of the circular disc. A metallic graduated scale with a movable pin-punch pointer is fixed to mark on the perimeter chart paper.
XTEMOS ELEMENT

AJAX PRODUCTS TABS LOAD MORE PAGINATION

Featured
  • Featured
  • Lighting
  • Accessories

SILICA CRUCIBLE WITHOUT LID

PRODUCT DESCRIPTION
  • Crucible is glazed inside and outside.
  • Highly resistant to alkalis and hot temperatures
  • 50ml capacity
  • Outside diameter 55mm, 42mm height
  • No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML

SILICA CRUCIBLE TALL FORM Without Lid, Translucent

PRODUCT DESCRIPTION -Without lid, translucent, glazed - Ordinary type lids to be purchased separately Size/ dimension:
  • 20ml,  Dia. 35mm x Ht. 38mm
  • 30ml, Dia. 43mm x Ht. 38mm
  • 50ml, Dia. 51mm x Ht. 51mm

SILICA MUFFLE TRAYS (For VM Crucible)

PRODUCT DESCRIPTION:   Available in 2types:  Two Hole, 39mm Length Four Hole, 76mm Length
XTEMOS ELEMENT

AJAX PRODUCTS TABS CAROUSEL

Featured
  • Featured
  • Cooking
  • Furniture