XTEMOS ELEMENT
AJAX PRODUCTS TABS
Automatic Knife Sharpener
Description
Portable, precision automatic knife sharpener with timer 0-60 minutes to adjust sharpening time. This equipment can sharpen all microtome knives up to 140 mm in length. Complete with one universal holder, two honing plates, one bottle honing glass compound, one knife inspection block and one re-dressing pad but without micro abrasives.
Behaviour Of Column Struts Apparatus
Apparatus consist of four spring steel columns which are put along a vertical wooden board. These four columns have different end conditions as below:
1. Both ends pinned
2. Both ends fixed
3. One end pinned and other fixed
4. One end fixed and other end free
Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Probe Type Anemometer Digital
Floating Magnet Set
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Probe Type Anemometer Digital
Cylinderical Magnet
Human Upper And Lower Jaw
francis turbine test setup
DESCRIPTION:
Francis Turbine is a reaction Turbine, which was developed by English born American Engineer Sir J.B. Francis. The water enters the turbine through the outer periphery of the runner in the radial direction and leaves the runner in axial direction and hence it is called a mixed flow turbine. As the water flows to the runner, a part of pressure energy goes on changing into kinetic energy. Thus the water through the runner is under pressure. The runner is completely enclosed in an air tight casing and the casing & runner is always full of water. The present Set-up consists of a runner. The water is fed to the turbine by Means of centrifugal Pump, radially to the runner. The runner is directly mounted on one end of a central SS shaft and other end is connected to a brake arrangement. The circular window of the turbine casing is provided with a transparent. The circular window of the turbine casing is provided with a transparent acrylic sheet for observation of flow on to the runner. The runner assembly is supported by thick cast iron pedestal. Load is applied to the turbine with the help of brake arrangement so that the efficiency of the turbine can be calculated. A draught tube is fitted on the outlet of the turbine. The Set-up is complete with guide mechanism. Pressure and vacuum Gauge are fitted at the Inlet and Outlet of the turbine to measure the total supply head on the turbine.UTILITIES REQUIRED:
● Water Supply and Drain.● Electricity 15 kW, 440V Ac, Three Phase
TECHNICAL SPECIFICATIONS:
| MODEL | HM 101 (1.33 HP) | HM 101 (2 HP) | HM 101 (5 HP) |
| Output Power | 1.33 HP / 1 Kw | 2 HP / 1 Kw | 5 HP / 3.75 Kw |
| Discharge | 1000 LPM (Approx.) | 1000 LPM (Approx.) | 2000 LPM (Approx.) |
| Supply Head | 10 m | 10 m | 15 m |
| Rope Brake Dynamometer | Dia 200 mm | Dia 200 mm | Dia 300 mm |
| Sump Tank | Capacity 300 Ltrs. | Capacity 300 Ltrs. | Capacity 600 Ltrs. |
| Water Circulation Centrifugal Pump | Capacity 5 HP, Three Phase | Capacity 5 HP, Three Phase | Capacity 15 HP, Three Phase |
| Speed | 1500 RPM (approx.) | ||
| Runner | Having Curved Vanes | ||
| Discharge Measurement | Pitot Tube with Manometer | ||
| Control Panel | Star/Delta Starter, Mains Indicator, MCB for overload protection | ||
| The whole set-up is well designed and arranged in a good quality painted structure. | |||
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Color Gauge Meter
Description
Color Gauge Meter Non-corrosive mounting hardware with weather resistant sealed lenses Superior quality internal components UV fade resistant race pointers Come with White Lights with Red removable cover Feature aluminum or plastic non-corrosive cases (automotive versions are steel) The AutoMeter Marine White Five Gauge Combination Kit is available in Standard or Monster Varieties and includes: 6000 RPM Tachometer Voltmeter Fuel Level Oil Pressure Water Temperature.
Bar & Gauge
Bucket & Cylinder
For demonstrating Archimedes principle this is a simple form in brass, suitable for class demonstration or individual use.
The bucket has suspension loop at the top and hook at the bottom.
The cylinder has a suspension hook at one end. Size 6 cm long, overall length when extended 16 cm.
A Bucket and Cylinder
B Bucket and Cylinder Large Size
Human Eye, 3 Times Enlarged
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Animal Cages
Available in two different sizes, the Animal Cages provide excellent shelter for different animal species in the laboratory.
The metallic top provides proper ventilation and has provisions for feeding the species.
Adding in line with the existing range, the Animal Cages are provided with a Stainless Steel grill at the bottom of the cage to provide a clean surface for the species to move on.
Material : Polypropylene / Stainless Steel
| Particulars | Pack (Pcs) | |
|---|---|---|
| Animal Cage ( 290 x 220 x 140 mm ) | 1 | |
| Animal Cage ( 430 x 270 x 150 mm ) | 1 | |
| Water Bottle 125 ml | 12 | |
| Water Bottle 250 ml | 12 | |
| Animal Cage Twin Grill ( 290 x 220 x 140 mm ) | 1 | |
| Animal Cage Twin Grill ( 430 x 270 x 150 mm ) | 1 |
Autoclave Vertical Sterilizer
Specifications
Made of stainless steel with the inner chamber of a thick pressure gauge. The outer surface has a mirror polish. The lid of this autoclave is thick along with a safety valve, pressure release valve, and drain valve. Spring loaded valve to adjust the pressure. Works on 220V AC. Radial or wing nut type door locking. Digital temperature indicator. Water level indicator.| Dimension | Power | Capacity | |
|---|---|---|---|
| 250x450mm | 2KW | 22litres | |
| 300x500mm | 3KW | 40litres | |
| 350x550mm | 4KW | 50litres | |
| 400x600mm | 5KW | 75litres | |
| 450x600mm | 5KW | 95litres | |
| 550x750mm | 6KW | 187litres |
ANALYTICAL BALANCE
DESCRIPTION
- Student Physical Balances with flat beam.
- Chemical Balances with Flat beam and rider using facility.
- Chainomatic Analytical Balances with external alteration of weights up to 100 mg.
- Analytical Balances with Triangular beam with rider using facility / Flat beam with vernier scale.
- Capacity 1mg to 100gms
- Capacity 1mg to 200gms
- IDDC Certified & Tested, 100gm
- Capacity 1mg to 500gm
- 1gm
- 2gm
- 5gm
- 10gm
- 20gm
- 50gm
- 100gm
- 200gm
Fuel Supply System Of A Diesel Engine
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Stop Watches
Carburetors Actual Cut Section
Reynold S Apparatus
DESCRIPTION:-
The Set-up is designed to verify Reynold’s Apparatus experimentally. The Apparatus consists of a glass tube which one end having bell mouth entrance connected to a water tank. At the other end of the glass tube a cock is provided to vary the rate of flow. Flow rate of water can be measured with the help of Measuring Cylinder and Stop Watch, supplied with the set-up. A capillary tube is introduced centrally in the bell mouth. To this tube dye is fed from a small container, placed at the top of Constant head Tank, through polythene tubing.EXPERIMENTS:-
Ø To study different types of flow. Ø To determine the Reynold’s Number and hence the type of floe either laminar or turbulent.UTILITIES REQUIRED: -
Ø Water Supply. Ø DrainTECHNICAL SPECIFICATION: - | ||
| Ø Tube | : | Material Borosilicate Glass |
| Ø Dye Vessel | : | Material SS, Suitable Capacity |
| Ø Capillary Tube | : | Material Copper/Stainless Steel |
| Ø Constant Head Water Tank | : | Capacity 40 Liters. |
| Ø Water Circulation | : | FHP Pump |
| Ø Flow Measurement | : | Using Measuring Cylinder |
| Ø Sump Tank | : | Capacity 60 Liters |
| Ø Stop Watch | : | Capacity 60 Liters. Electronic |
| Ø Control Panel Comprises of | : | Standard make, On/Off Switch, Mains Indicator, etc. |
| Ø The Whole set-up is well designed and arranged in a good quality painted structure. | ||
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Linear Expansion Apparatus
Consisting of a metal rod, 500mm in length and 4.5mm diameter, enclosed in a well lagged, nickle plated brass tube with three tubules for steam, inlet, outlet and thermometer.
The metal rod to be studied is supported in the steam jacket by detachable conical cups situated at each end of the tube.
The apparatus is carried on a heavy gauge channel base at one end of which is an adjusting screw.
At the opposite end is a micrometer screw reading to 0.01mm for measuring the expansion.
Supplied complete with copper, brass & iron rods but without thermometer.
Orbital Shaking Incubator
Specification
Outer made of M.S. Sheet powder coated & inner chamber is made of thick S.S. Sheet. The gap between two walls is fitted with high grade glass wool. The glass window makes it possible to inspect specimen without disturbing inner Temperature. The unit has a temprature range from ambient to 60°. Temperature is controlled by Dual Display Microprocessor PID Digital Temperature Indicator Cum Controller with a accuracy of + 0.5°C. Air Circulation Fan is provided to maintain stability throughout. Speed of shaker is variable from 30 RPM to 250 RPM. The tray of the shaker is also made of S.S. Sheet with Lotus type clamps to hold flasks. Unit is fitted with Digital RPM Meter, 999 min digital time.Optional Accessories
Timer 0-24 Hours. 16 Flasks of 100ml. instead of 9 flasks of 250ml. 9 Flasks of 500ml or 25 flasks of 100ml instead of 16 flasks of 250ml. 25 Flasks of 250ml or 36 flasks of 100ml instead of 16 flasks of 500ml.Size
9 Flasks of 250ml. 16 Flasks of 250ml. 16 Flasks of 500ml.
Water Bath Incubator Shaker
Specifications
Similar to other water bath but fitted with inbuilt shaker for differrent experiments demanding shaking at constant speed under controlled temerature conditions. The temprature is controlled by capillary type thermostat from ambient to 100°C. RPM range :- 40-140 with variable electronic speed regulattor workable on 220V AC 50 Hz Single Phase.| Chamber Size In mms (dia x depth) | Capacity (L) | |
|---|---|---|
| 275x275x150 | 12 L | |
| 405x300x150 | 18 L |
Optional (Extra Cost)
Microprocessor PID digital temp. indicator cum contrroller. Digital RPM meter. Auto cut off device when water level is low.
Flourimeter (Digital)
A digital photofluorometer, you can perform precise analysis of flurophors and quinine.
Designed specifically for life science laboratories, this smart instrument fulfills your requirements of accurate results with the sensitivity you demand.
This fluorometer is a compact system, which occupies very low bench space, while offering convenient and excellent throughput for fluorescence assays.
It is a fluorometer model has been designed and manufactured for laboratories, where routine analysis of fluorophors is a prime requisite.
This system uses 50 W tungsten halogen lamp,
This digital fluorometer greatly enhances productivity of your laboratory, designed with latest technology, use of imported mechanical and electrical parts, imported lamp and other components; it allows you to perform fluorometric determination of quinine more quickly.
| Covers entire visible range: | Excellent detection sensitivity | |
| Compact and efficient: | Bright red seven segment LED display | |
| Occupies low bench space: | Precise analysis of Flurophors & Quinine |
Specifications
| Fluoro Sensitivity: | Full-scale deflection obtained with 1 ppm quinine sulfate in 0.1 N sulphuric acid (primary wavelength 360 nm) | |
| Display: | 3 digits bright red seven segments LED display | |
| Excitation Source: | 12V, 50W Tungsten Halogen Lamp | |
| Sensitivity Range: | Adjustable in 4 ranges | |
| Detector: | Highly sensitive wide range photodiode/cell | |
| Sample Test Tube Size: | 15 mm (D) x 80 mm (H) | |
| Minimum Sample: | 4 ml | |
| Power: | 230 V ± 10%, 50 Hz. AC | |
| Dimension: | 260 x 335 x 160 mm (Approx.) |
Vacuum Assisted Hydraulic Drum Brake
Vacuum Assisted Hydraulic Drum Brake With Vacuum Booster & Motorised Vacuum Pump
Suitably sectionised full size unit. Consisting of original parts such as :- vacuum booster with master cylinder assembly, wheel cylinder, brake shoes, brake drums, motorised vacuum pump and necessary connections. Completed with operating lever and mounted on heavy iron stand.
